
2-7/8" x 20" Calcite & Coconut Shell GAC Filter Cartridge
In stock
Not sure about subscribing? Most customers tell us they signed up to stop forgetting — not to save 5%. Your cartridge is good for 12 to 24 months. After that, the calcite is used up, the pH drifts back down, and the flat, acidic taste returns.
Subscribe and you'll get a fresh cartridge automatically — right when the old one wears out. Cancel, pause, or change your schedule anytime in your account. No phone calls, no obligation, no fees.
A cartridge that pairs calcite, to raise low pH, with coconut shell carbon to polish taste and odor.
- Raises low pH toward neutral
- Rated for 8,000 gallons
- Typical life: 12 to 24 months
- Measures 2-7/8 x 20 in and fits a standard 2.5 x 20 in housing
Replacement cartridge, 2-7/8 x 20 in
Balance acidic water and polish its taste
Acidic, low-mineral water can taste flat and is hard on copper and brass plumbing. Calcite dissolves gently into the water to bring the pH toward neutral, and coconut shell carbon in the same cartridge polishes taste and odor.
- Raises low pH toward neutral
- Rated for 8,000 gallons
- Typical life: 12 to 24 months
- Fits a standard 2.5 x 20 in housing

What a fresh cartridge gives you
Balanced water
Brings acidic water toward a neutral, less corrosive pH with no chemical feed.
Kinder to plumbing
Water nearer neutral is less corrosive to copper and brass.
Better taste
Coconut shell carbon polishes taste and odor, including chlorine taste.
How it works
Calcite
Natural calcium carbonate that dissolves slowly into acidic water.
Self-limiting
Calcite corrects toward neutral and does not overshoot under normal conditions.
Coconut shell carbon
A polishing stage for taste and odor.
What it does
Designed to
- Raise low pH toward neutral
- Add calcium back to low-mineral water
- Polish taste and odor, including chlorine taste
Not designed for
- Neutral or alkaline water
- Fluoride and nitrate
- Lead and other heavy metals
- Iron
- Bacteria and viruses
The pH you end up with depends on your incoming water. Test the pH after installing and again as the cartridge ages.

Find your size
Match the actual size printed on your current cartridge. This one measures 2-7/8 x 20 in and fits a standard 2.5 x 20 in housing, the size used in our compact whole house systems.
| Cartridge size | Fits | Service flow |
|---|---|---|
| 2-7/8 x 9-3/4 in | 2.5 x 10 in housing | 0.5 gpm |
| 2-7/8 x 20 in (this cartridge) | 2.5 x 20 in housing | 2.5 gpm |

Specifications
| Part number | CQE-RC-04024 |
|---|---|
| Cartridge size | 2-7/8 x 20 in (actual) |
| Fits | Standard 2.5 x 20 in housing |
| Service flow | 2.5 gpm |
| Rated capacity | 8,000 gallons (at under 100 ppm hardness) |
| Typical life | 12 to 24 months |
| Media | Calcite and coconut shell carbon |
| Water temperature | 40 to 145°F |
| Made in | USA |
How to replace it
A few minutes, with the wrench that came with your system.
- Turn off the water supply to the filter and release the pressure as your system manual directs. Place a towel or drip pan underneath.
- Unscrew the housing with the housing wrench and lift out the used cartridge.
- Wash the housing with mild soap and water and rinse it well.
- Check that the O-ring is clean and fully seated in its groove.
- Unwrap the new cartridge and set it in, centered and fully seated. If one end is marked "This End Up, Toward Cap", that end faces the cap.
- Screw the housing back on by hand, then snug it with the wrench. Do not overtighten.
- Turn the water on slowly, check for leaks, then flush the new cartridge before first use.
Timing and care tips are in the Replacement Schedule tab. Questions about fit? Contact us.
| SKU | CQE-RC-04024 |
|---|---|
| Country of Manufacture | United States |
| On Sale | No |
When to replace it
Typically every 12 to 24 months, or when you reach the rated gallons, whichever comes first. A falling pH is the sign that the calcite is spent.
- Replace it when the pH of the filtered water starts to fall.
- Replace it sooner if the taste, flow or pressure changes.
How to replace it
- Turn off the water supply to the filter and release the pressure as your system manual directs. Place a towel or drip pan underneath.
- Unscrew the housing with the housing wrench and lift out the used cartridge.
- Wash the housing with mild soap and water and rinse it well.
- Check that the O-ring is clean and fully seated in its groove.
- Unwrap the new cartridge and set it in, centered and fully seated. If one end is marked "This End Up, Toward Cap", that end faces the cap.
- Screw the housing back on by hand, then snug it with the wrench. Do not overtighten.
- Turn the water on slowly, check for leaks, then flush the new cartridge before first use.
Between changes
- Test the pH after installing and again as the cartridge ages.
- Write the install date on the cartridge label or in your calendar so the next change is easy to time.
Never run late on a change. Choose Subscribe and save when you order and a fresh cartridge arrives on the schedule you set, with 5% off each delivery.
Questions about timing? Contact us.
Calcite and Coconut Carbon Filter Cartridge FAQ
How does calcite raise pH?
Calcite is natural calcium carbonate. It dissolves slowly into acidic water, which neutralizes the acidity and adds a little calcium.
Will it make my water too alkaline?
Calcite is self-limiting. It corrects toward neutral and does not overshoot under normal conditions.
Do I need it if my water is already neutral?
No. It is made for acidic, low-mineral water.
How often should I replace the calcite cartridge?
Typically every 12 to 24 months, or when you reach the rated gallons, whichever comes first. A falling pH is the sign that the calcite is spent.
Which size do I need?
Match the actual size printed on your current cartridge. This cartridge measures 2-7/8 x 20 in and fits a standard 2.5 x 20 in housing. Housings are often named by nominal size, which is slightly larger than the cartridge itself.
How do I replace it?
Turn off the water supply to the filter and release the pressure as your system manual directs. Place a towel or drip pan underneath. Unscrew the housing with the housing wrench and lift out the used cartridge. Fit the new cartridge, turn the water on slowly, check for leaks and flush before first use. Full steps are in the Replacement Schedule tab.
Can I have replacements delivered automatically?
Yes. Choose Subscribe and save when you order and a fresh cartridge arrives on the schedule you set, with 5% off each delivery. You can pause, change or cancel anytime in your account.
