
2-7/8" x 20" UF Membrane Filter Cartridge
In stock
Not sure about subscribing? Most customers tell us they signed up to stop forgetting — not to save 5%. Your cartridge is good for 24 to 36 months. After that, the membrane loads up, the flow slows, and it stops filtering the way it did when new.
Subscribe and you'll get a fresh cartridge automatically — right when the old one wears out. Cancel, pause, or change your schedule anytime in your account. No phone calls, no obligation, no fees.
A 0.1 micron ultrafiltration membrane cartridge that reduces bacteria, cysts and fine particles while keeping natural minerals.
- Reduces bacteria and cysts
- Typical life: 24 to 36 months
- Measures 2-7/8 x 20 in and fits a standard 2.5 x 20 in housing
Replacement cartridge, 2-7/8 x 20 in
Very fine filtration that keeps the minerals in
An ultrafiltration membrane filters far finer than a sediment or carbon stage. It holds back bacteria, cysts and fine particles while letting dissolved minerals through, so your water keeps its natural taste. It needs no drain, makes no wastewater and uses no electricity.
- Reduces bacteria and cysts
- 0.1 micron UF membrane
- Typical life: 24 to 36 months
- Fits a standard 2.5 x 20 in housing

What a fresh cartridge gives you
Finer than standard filters
A 0.1 micron membrane, far finer than a typical sediment or carbon stage.
Minerals stay in
Dissolved minerals pass through, so water keeps its natural taste.
No waste, no power
No drain connection, no wastewater and no electricity.
How it works
Pleated UF membrane
A membrane with pores of about 0.1 micron.
Filtration by size
Bacteria, cysts and fine particles are too large to pass.
Minerals pass through
Water and dissolved minerals flow through the membrane.
What it reduces
Designed to reduce
- Bacteria
- Protozoa and cysts, such as Giardia and Cryptosporidium
- Colloids, turbidity and fine particles
- Viruses, partially
Not designed for
- Chlorine and chloramine
- VOCs
- Lead, fluoride, nitrate and arsenic
- Water hardness
- Total dissolved solids (TDS)
Where viruses are a specific concern, pair it with a UV sterilizer or reverse osmosis. For chlorine and chemicals, pair it with a SMART cartridge.

Find your size
Match the actual size printed on your current cartridge. This one measures 2-7/8 x 20 in and fits a standard 2.5 x 20 in housing, the size used in our compact whole house systems.
| Cartridge size | Fits | Service flow |
|---|---|---|
| 2-7/8 x 9-3/4 in | 2.5 x 10 in housing | 0.5 gpm |
| 2-7/8 x 20 in (this cartridge) | 2.5 x 20 in housing | 2.5 gpm |

Specifications
| Part number | CQE-RC-04056 |
|---|---|
| Cartridge size | 2-7/8 x 20 in (actual) |
| Fits | Standard 2.5 x 20 in housing |
| Service flow | 2.5 gpm |
| Typical life | 24 to 36 months |
| Membrane | Pleated ultrafiltration (UF) |
| Membrane rating | 0.1 micron nominal |
| Wastewater | None |
| Made in | USA |
How to replace it
A few minutes, with the wrench that came with your system.
- Turn off the water supply to the filter and release the pressure as your system manual directs. Place a towel or drip pan underneath.
- Unscrew the housing with the housing wrench and lift out the used cartridge.
- Wash the housing with mild soap and water and rinse it well.
- Check that the O-ring is clean and fully seated in its groove.
- Unwrap the new cartridge and set it in, centered and fully seated. If one end is marked "This End Up, Toward Cap", that end faces the cap.
- Screw the housing back on by hand, then snug it with the wrench. Do not overtighten.
- Turn the water on slowly, check for leaks, then flush the new cartridge before first use.
Timing and care tips are in the Replacement Schedule tab. Questions about fit? Contact us.
| SKU | CQE-RC-04056 |
|---|---|
| Country of Manufacture | United States |
| On Sale | No |
When to replace it
Typically every 24 to 36 months. Replace it sooner if the flow drops. Actual life depends on your water quality and how much water you use.
- Replace it sooner if the flow drops.
How to replace it
- Turn off the water supply to the filter and release the pressure as your system manual directs. Place a towel or drip pan underneath.
- Unscrew the housing with the housing wrench and lift out the used cartridge.
- Wash the housing with mild soap and water and rinse it well.
- Check that the O-ring is clean and fully seated in its groove.
- Unwrap the new cartridge and set it in, centered and fully seated. If one end is marked "This End Up, Toward Cap", that end faces the cap.
- Screw the housing back on by hand, then snug it with the wrench. Do not overtighten.
- Turn the water on slowly, check for leaks, then flush the new cartridge before first use.
Between changes
- Keep a sediment stage ahead of it so the membrane does not load up early.
- Write the install date on the cartridge label or in your calendar so the next change is easy to time.
Never run late on a change. Choose Subscribe and save when you order and a fresh cartridge arrives on the schedule you set, with 5% off each delivery.
Questions about timing? Contact us.
Ultrafiltration (UF) Membrane Filter Cartridge FAQ
What does a UF membrane reduce?
Bacteria, protozoan cysts such as Giardia and Cryptosporidium, colloids and fine particles. It reduces viruses partially.
Does ultrafiltration take out minerals?
No. Dissolved minerals pass through, so the water keeps its natural taste.
Does it waste water like reverse osmosis?
No. There is no drain connection and no wastewater.
Does it reduce chlorine or fluoride?
No. Dissolved chemicals pass through a UF membrane. Pair it with a carbon, SMART or fluoride stage.
How often should I replace the UF membrane cartridge?
Typically every 24 to 36 months. Replace it sooner if the flow drops. Actual life depends on your water quality and how much water you use.
Which size do I need?
Match the actual size printed on your current cartridge. This cartridge measures 2-7/8 x 20 in and fits a standard 2.5 x 20 in housing. Housings are often named by nominal size, which is slightly larger than the cartridge itself.
How do I replace it?
Turn off the water supply to the filter and release the pressure as your system manual directs. Place a towel or drip pan underneath. Unscrew the housing with the housing wrench and lift out the used cartridge. Fit the new cartridge, turn the water on slowly, check for leaks and flush before first use. Full steps are in the Replacement Schedule tab.
Can I have replacements delivered automatically?
Yes. Choose Subscribe and save when you order and a fresh cartridge arrives on the schedule you set, with 5% off each delivery. You can pause, change or cancel anytime in your account.
