natural (Alkalinize)ionizer, mineralizer and oxidation cartridge

SKU : CQE-RC-04058

In stock

Subscription details

Not sure about subscribing? Most customers tell us they signed up to stop forgetting — not to save 5%. Your cartridge is good for 12 to 24 months. After that, the mineral blend is used up, and the flat taste it was correcting comes back.

Subscribe and you'll get a fresh cartridge automatically — right when the old one wears out. Cancel, pause, or change your schedule anytime in your account. No phone calls, no obligation, no fees.

A mineralizing cartridge with a natural calcite and magnesium oxide blend that adds calcium and magnesium and raises pH.

  • Adds calcium and magnesium
  • Typical life: 12 to 24 months
  • Measures 2-7/8 x 9-3/4 in and fits a standard 2.5 x 10 in housing

Replacement cartridge, 2-7/8 x 9-3/4 in

Put the minerals back and brighten the taste

Reverse osmosis and naturally soft water can taste flat. This cartridge holds a natural blend of calcite and magnesium oxide that dissolves gently into the water, adding calcium and magnesium and raising pH and alkalinity.

  • Adds calcium and magnesium
  • Raises pH and alkalinity
  • Typical life: 12 to 24 months
  • Fits a standard 2.5 x 10 in housing
Alkalizer and Mineralizer Filter Cartridge, single 2-7/8 x 9-3/4 inch green cartridge, front view

What a fresh cartridge gives you

Rounder taste

Restores the mineral body that purified and very soft water lacks.

Higher pH

Raises pH and alkalinity, so water is less acidic and less corrosive.

Natural minerals

A blend of calcite and magnesium oxide, with nothing synthetic added.

12-24Months, typical life
0.5GPM service flow
5%Off with Subscribe and save
USAMade in

How it works

1

Mineral media

A blend of calcite and magnesium oxide.

2

Gentle dissolving

The media dissolves slowly as water passes, which neutralizes acidity.

3

Last in line

It goes after your filtration stages, so it mineralizes clean water.

What it does

Designed to

  • Add calcium and magnesium
  • Raise pH and alkalinity
  • Improve the flat taste of low-mineral water
  • Make acidic water less corrosive

Not designed for

  • Chlorine and chemicals
  • Lead and other heavy metals
  • Fluoride, nitrate and arsenic
  • Bacteria and viruses

It is a mineralizer, not a contaminant filter. Install it after your filtration stages. The pH you end up with depends on your incoming water, flow and contact time.

Alkalizer and Mineralizer Filter Cartridge, Mineralizer & Oxidation Cartridge, 2-7/8 inch size: close-up of the top cap and white gasket around the th

Find your size

Match the actual size printed on your current cartridge. This one measures 2-7/8 x 9-3/4 in and fits a standard 2.5 x 10 in housing, the size used in our countertop, under sink and refrigerator systems.

Cartridge sizeFitsService flow
2-7/8 x 9-3/4 in (this cartridge)2.5 x 10 in housing0.5 gpm
Alkalizer and Mineralizer Filter Cartridge, green cartridge with 2-7/8 inch diameter, 9-3/4 inch height callouts

Specifications

Part numberCQE-RC-04058
Cartridge size2-7/8 x 9-3/4 in (actual)
FitsStandard 2.5 x 10 in housing
Service flow0.5 gpm
Typical life12 to 24 months
MediaCalcite and magnesium oxide blend
Water temperature40 to 145°F
Made inUSA

How to replace it

A few minutes, with the wrench that came with your system.

  1. Turn off the water supply to the filter and release the pressure as your system manual directs. Place a towel or drip pan underneath.
  2. Unscrew the housing with the housing wrench and lift out the used cartridge.
  3. Wash the housing with mild soap and water and rinse it well.
  4. Check that the O-ring is clean and fully seated in its groove.
  5. Unwrap the new cartridge and set it in, centered and fully seated. If one end is marked "This End Up, Toward Cap", that end faces the cap.
  6. Screw the housing back on by hand, then snug it with the wrench. Do not overtighten.
  7. Turn the water on slowly, check for leaks, then flush the new cartridge before first use.

Timing and care tips are in the Replacement Schedule tab. Questions about fit? Contact us.

SKU CQE-RC-04058
Country of Manufacture United States
On Sale No
Write Your Own Review
You're reviewing: natural (Alkalinize)ionizer, mineralizer and oxidation cartridge
loader
Loading...

check-circle You submitted your review for moderation.

This form is protected by reCAPTCHA - the Google Privacy Policy and Terms of Service apply.

When to replace it

Typically every 12 to 24 months. The media is used up as it dissolves, so replace it sooner if the taste goes flat again or the flow changes.

  • Replace it sooner if the taste goes flat again.
  • Replace it sooner if the flow or pressure changes.

How to replace it

  1. Turn off the water supply to the filter and release the pressure as your system manual directs. Place a towel or drip pan underneath.
  2. Unscrew the housing with the housing wrench and lift out the used cartridge.
  3. Wash the housing with mild soap and water and rinse it well.
  4. Check that the O-ring is clean and fully seated in its groove.
  5. Unwrap the new cartridge and set it in, centered and fully seated. If one end is marked "This End Up, Toward Cap", that end faces the cap.
  6. Screw the housing back on by hand, then snug it with the wrench. Do not overtighten.
  7. Turn the water on slowly, check for leaks, then flush the new cartridge before first use.

Between changes

  • Install it after your filtration stages, so it mineralizes clean water.
  • Write the install date on the cartridge label or in your calendar so the next change is easy to time.

Never run late on a change. Choose Subscribe and save when you order and a fresh cartridge arrives on the schedule you set, with 5% off each delivery.

Questions about timing? Contact us.

Alkalizer and Mineralizer Filter Cartridge FAQ

What does an alkalizer cartridge add to water?

Calcium, magnesium and alkalinity, from a natural blend of calcite and magnesium oxide.

Does it filter contaminants?

No. It is a mineralizing stage. Install it after your filtration stages.

What pH will my water be?

It is not fixed. The result depends on your incoming water, the flow and the contact time.

How often should I replace the alkalizer cartridge?

Typically every 12 to 24 months. The media is used up as it dissolves, so replace it sooner if the taste goes flat again or the flow changes.

Which size do I need?

Match the actual size printed on your current cartridge. This cartridge measures 2-7/8 x 9-3/4 in and fits a standard 2.5 x 10 in housing. Housings are often named by nominal size, which is slightly larger than the cartridge itself.

How do I replace it?

Turn off the water supply to the filter and release the pressure as your system manual directs. Place a towel or drip pan underneath. Unscrew the housing with the housing wrench and lift out the used cartridge. Fit the new cartridge, turn the water on slowly, check for leaks and flush before first use. Full steps are in the Replacement Schedule tab.

Can I have replacements delivered automatically?

Yes. Choose Subscribe and save when you order and a fresh cartridge arrives on the schedule you set, with 5% off each delivery. You can pause, change or cancel anytime in your account.

Recommended Products

Single Countertop Fluoride
$99.00
Armour Stainless Steel Fluoride Gravity Water Filter System
$219.99
Double countertop Fluoride
$148.35
Black Fluoride Pitcher Filter
$42.95

Related Products

SMART Plus Multi Stage Filter Cartridge, 2-7/8 x 9-3/4 inch, single blue cartridge with white label, front view
$59.00
Coconut Carbon Block Filter Cartridge, 2-7/8 x 9-3/4 inch single gray mesh-wrapped block with white end caps
$32.95
Shower Filter Cartridge
$29.50
5 Micron Pleated Sediment Filter Cartridge, 2-7/8 x 9-3/4 inch single white pleated cartridge with blue end caps, front view
$22.95