
natural (Alkalinize)ionizer, mineralizer and oxidation-sealed
In stock
Not sure about subscribing? Most customers tell us they signed up to stop forgetting — not to save 5%. Your cartridge is good for 12 to 24 months. After that, the mineral blend is used up, and the flat taste it was correcting comes back.
Subscribe and you'll get a fresh cartridge automatically — right when the old one wears out. Cancel, pause, or change your schedule anytime in your account. No phone calls, no obligation, no fees.
A sealed inline mineralizing cartridge that adds calcium and magnesium and raises the pH of reverse osmosis water.
- Adds calcium and magnesium
- Typical life: 12 to 24 months
- For RO systems and coolers
Replacement cartridge
Put the minerals back and brighten the taste
Reverse osmosis and naturally soft water can taste flat. This cartridge holds a natural blend of calcite and magnesium oxide that dissolves gently into the water, adding calcium and magnesium and raising pH and alkalinity.
- Adds calcium and magnesium
- Sealed inline cartridge
- Typical life: 12 to 24 months
- For RO systems and coolers

What a fresh cartridge gives you
Rounder taste
Restores the mineral body that purified and very soft water lacks.
Higher pH
Raises pH and alkalinity, so water is less acidic and less corrosive.
Natural minerals
A blend of calcite and magnesium oxide, with nothing synthetic added.
How it works
Mineral media
A blend of calcite and magnesium oxide.
Gentle dissolving
The media dissolves slowly as water passes, which neutralizes acidity.
Last in line
It goes after your filtration stages, so it mineralizes clean water.
What it does
Designed to
- Add calcium and magnesium
- Raise pH and alkalinity
- Improve the flat taste of low-mineral water
- Make acidic water less corrosive
Not designed for
- Chlorine and chemicals
- Lead and other heavy metals
- Fluoride, nitrate and arsenic
- Bacteria and viruses
It is a mineralizer, not a contaminant filter. Install it after your filtration stages. The pH you end up with depends on your incoming water, flow and contact time.

Where it fits
It is the optional mineralizing stage for our under sink reverse osmosis systems, countertop reverse osmosis system and bottleless water coolers. It goes after the filtration stages.

Specifications
| Part number | CQE-RC-04054 |
|---|---|
| Typical life | 12 to 24 months |
| Media | Calcite and magnesium oxide blend |
| Format | Sealed inline cartridge with a connector at each end |
| Operating pressure | 20 to 60 psi |
| Water temperature | Cold water, 40 to 90°F |
| Made in | USA |
How to replace it
A few minutes. There is no housing to open.
- Shut off the water supply to the filter line and place a towel underneath.
- Release the pressure as your system manual directs, then disconnect the fittings from the used cartridge.
- Check that the new cartridge has the same connection style, and fit it in the same direction. The arrow on the label shows the direction of flow.
- On threaded connections, wrap the threads with thread seal tape before connecting.
- Turn the water on slowly and check each connection for leaks.
- Flush the new cartridge before first use.
Timing and care tips are in the Replacement Schedule tab. Questions about fit? Contact us.
| SKU | CQE-RC-04054 |
|---|---|
| Country of Manufacture | United States |
| On Sale | No |
Customer Reviews
When to replace it
Typically every 12 to 24 months. The media is used up as it dissolves, so replace it sooner if the taste goes flat again or the flow changes.
- Replace it sooner if the taste goes flat again.
- Replace it sooner if the flow or pressure changes.
How to replace it
- Shut off the water supply to the filter line and place a towel underneath.
- Release the pressure as your system manual directs, then disconnect the fittings from the used cartridge.
- Check that the new cartridge has the same connection style, and fit it in the same direction. The arrow on the label shows the direction of flow.
- On threaded connections, wrap the threads with thread seal tape before connecting.
- Turn the water on slowly and check each connection for leaks.
- Flush the new cartridge before first use.
Between changes
- Install it after your filtration stages, so it mineralizes clean water.
- Write the install date on the cartridge label or in your calendar so the next change is easy to time.
Never run late on a change. Choose Subscribe and save when you order and a fresh cartridge arrives on the schedule you set, with 5% off each delivery.
Questions about timing? Contact us.
Inline Alkalizer and Mineralizer Cartridge FAQ
What does an alkalizer cartridge add to water?
Calcium, magnesium and alkalinity, from a natural blend of calcite and magnesium oxide.
Does it filter contaminants?
No. It is a mineralizing stage. Install it after your filtration stages.
What pH will my water be?
It is not fixed. The result depends on your incoming water, the flow and the contact time.
How often should I replace the alkalizer cartridge?
Typically every 12 to 24 months. The media is used up as it dissolves, so replace it sooner if the taste goes flat again or the flow changes.
How do I replace it?
Shut off the water supply to the filter line and place a towel underneath. Release the pressure as your system manual directs, then disconnect the fittings from the used cartridge. Fit the new cartridge, turn the water on slowly, check for leaks and flush before first use. Full steps are in the Replacement Schedule tab.
Can I have replacements delivered automatically?
Yes. Choose Subscribe and save when you order and a fresh cartridge arrives on the schedule you set, with 5% off each delivery. You can pause, change or cancel anytime in your account.
